Specifications

A-5200-030-280
© 1991-1995 Radionics
74-06176-000-B 9/95
D5200 Programmer Operation Manual
Page 29
7. Receiving (Copying) Records
A record can be copied from a control/communicator or other device into the D5200
Programmer. The D5203 programmer cord can be connected directly to panels with 4-pin
PROG ports and phone jack PROG ports.
Connecting the Programmer
Panel with 4-Pin PROG Port
The D5200 Programmer can be connected directly to a device with a 4-pin male programming
connector (D4112, D7112, D636, and D2071 control/communicators) as shown in Figure 20.
1. Plug the programmer cord's male phone plug into the D5200 COMMUNICATOR port.
2. Plug the programmer cord's 4-pin female connector into the 4-pin male programming
(PROG) port on the panel.
Panel with Phone Jack PROG Port
A D5206 adapter is no longer necessary with the D5200 for devices with a 4-pin female phone
jack (D6112 Control/Communicator, D8112 Control/Communicator, D6500 Receiver). The
new D5203 cord has a phone jack connection. An example of this type of connection is shown
in Figure 21.
1. Plug the programmer cord's male phone plug into the D5200 COMMUNICATOR port.
2. Plug the programmer cord's 4-pin female connector into the panel programming phone
jack (PROG).
Receiving (Copying) the Program
To copy a record from a panel into the programmer:
1. Scroll to the appropriate product handler from the Product Handlers menu using the red
↓ or ↑ keys, and press the red ENTER GROUP key.
2. Place the flashing cursor on a record title (or NEWRECORD). This is the record to which
the panel program will be copied. Press the red RECV (COPY) key. The message
RECEIVING is displayed while the record is uploading from the panel into the programmer.
When the record copy is complete, the message RECEIVE SUCCESSFUL is displayed.
Plug In Device: If this message appears, check the connection from the programmer to
the device, and verify that the handler of the record selected is appropriate for the device
to which the programmer is connected.
Tweedle: The programmer tweedles if an attempt is made to copy a program with no
record title (or NEWRECORD) selected by the flashing cursor.
INVALID LOCK CODE: Displays if the panel lockcode does not match any of the
lockcodes in the programmer. See the Lockcodes chapter for more information.
RECEIVE FAILURE or Comm Error: These messages are displayed if a communi-
cation error disrupts the copy process.
3. After a successful copy, the copied record is automatically entered, and module,
category, or program item titles are displayed. The copied record can be saved under a
different name, or replace the current record (see the Editing a Record section in the
Programming Records chapter).