Specifications

D5200 Programmer Operation Manual

Page 22

74-06176-000-B 9/95

A-5200-030-220

REPLACING the Record: To save the edited record under the

original name

(replace

the old record), press the red EXIT GROUP key when the SAVE display appears. The cursor

flashes on REPLACE. Press the red ENTER GROUP key. The name of the record

automatically appears in the REPLACE display (see Figure 14). To replace the record,

press the white ENTER key. The message RECORD REPLACED is displayed. Press the

red EXIT GROUP key to return to the Record Level.

NOTE: This feature is

password dependent

. If the programmer is logged onto with a

password that does not have the authority to replace records, the message ACCESS

DENIED is displayed when trying to access this feature.

DISCARDING CHANGES to the Record: To discard changes that have been made to

the record, simply press the red EXIT GROUP key when the SAVE display appears, and

proceed to step 9.

RECORD NOT REPLACED: This message is displayed if the name entered (i.e. default

current record title not used) does not match any record titles on the current disk. Check

the title entered in the NAME field – it must exactly match the title of the record stored

on the current disk.

REPLACE

NAME: RESIDENTIAL4

Figure 14: REPLACING A RECORD

READ ONLY RECORD: This message is displayed if the record you are trying to replace

is locked. The edited record can be saved only under a different name.

9. Press the red EXIT GROUP key to return to the Record level.

10. Press the red EXIT GROUP key again to return to the Product Handlers level.