Specifications

D5200 Programmer Operation Manual
Page 20
© 1991-1995 Radionics
74-06176-000-B 9/95
A-5200-030-200
Indexed Group Entry Example
Exit the Phone category using the red EXIT GROUP key as described in the previous section.
Move the cursor to the Phone Routing category in the Panel Wide Parameters module, and
press the red ENTER GROUP key. The cursor flashes on the default entry of 1 to the right of
the Phone program item. Note that the program items below Phone also have the number
1 (Ph
11
11
1 Fire Alarm/Res, Ph
11
11
1 Fire Tbl/Res, etc.). Press the 2 key and the white ENTER
key. The titles of the next program items change to reflect this entry (Ph
22
22
2 Fire Alarm/Res,
Ph
22
22
2 Fire Trouble/Res, etc.). The program items within the Phone Routing group are
indexed to the entry of the Phone program item.
Press the red EXIT GROUP key to exit the Phone Routing category.
Phone Routing
Phone 2
Ph2 Fire Alarm/Res P
Ph2 Fire Tbl/Res P
This entry ...
... changes these prompts
Figure 12: INDEXED PROGRAM ITEMS
SAVE
NAME: RESIDENTIAL4
Figure 13: SAVING A RECORD
Programmer Tip – Record Names
• It is recommended that programmer prompts such as NEWRECORD, LOCKRECORD,
VISMODE, COPY, DELETE, not be used as record names.
• The programmer does not accept a blank (all spaces) record name.
The cursor returns to the NEWRECORD menu, and flashes on REPLACE. To return to the
D7112 record level, press the red EXIT GROUP key.
Exiting a Module
To exit a module such as Panel Wide Parameters, press the red EXIT GROUP key. The cursor
returns to the NEWRECORD menu.
Exiting a Record
To exit a record, press the red EXIT GROUP key.
Saving a New Record
If changes have been made to any program items, the SAVE display appears (see Figure 13).
To save a new record, type a name (up to 12 characters) in the NAME field, and press the
white ENTER key. A message indicates that the record has been saved. The cursor remains
in the SAVE display, allowing the record to be saved under an additional name.