Specifications

D5200 Programmer Operation Manual

Page 19

74-06176-000-B 9/95

A-5200-030-180

Programmer Tips – Making Corrections

The following keys can be used to change data entered for a program item:

• Use the white BACKSPACE key on the programmer keyboard to erase characters.

• Use the red ← and → arrow keys to move the cursor to any character in the entry.

(The arrow keys do not erase characters.)

• Use the red CLEAR key to erase the entire entry.

• Use the red CANCEL key to return the entry to its default entry.

Yes/No Entry Example

Move the cursor to Modem Format. The cursor flashes on the default entry Yes.

Press the white SPACE bar on the keyboard to toggle the entry to Yes. Pressing the SPACE

bar again toggles the entry back to No. Yes and No entries can also be achieved by pressing

the Y key or the N key on the keyboard.

When the appropriate Yes/No entry has been selected, press the white ENTER key on the

programmer keyboard. The cursor moves down to the next program item.

Choice List Entry Example

Using the red ↓ key, move the cursor to Phone Supv Time. The cursor flashes in the blank

space to the right of the Phone Supv Time label.

Press the white SPACE bar on the keyboard to scroll through the programming choices

available: 2Min, 4Min, 8Min, blank (No Supervision).

When the appropriate entry has been selected, press the white ENTER key on the

programmer keyboard. The cursor moves down to the next program item.

Programmer Tip – Choice List Data Entry

Only the entries displayed using the SPACE bar will be accepted by the programmer for

choice list

entries. If numbers or letters are typed in using the keyboard, the programmer

will "tweedle" when the ENTER key is pressed.

To view valid choices, move the cursor back to the first character, using the red CANCEL,

CLEAR, or ← key, and press the SPACE bar.

Exiting a Category

To exit a category (i.e. Phone), press the red EXIT GROUP key. The cursor returns to the

module level, and flashes on the next module title AREA WIDE PARAMETERS.

NOTE: The programmer will "tweedle" if the cursor is flashing on program item data that has

not been entered. Press the white ENTER key to enter data or the red CANCEL key to return

the previous entry, and then press the red EXIT GROUP key.