Specifications
D5200 Programmer Operation Manual
Page 1
© 1991-1995 Radionics
74-06176-000-B 9/95
A-5200-030-00
Notice
The material and instructions in this manual have been carefully checked for accuracy and are presumed to be
reliable. However, Radionics, Inc. assumes no responsibility for inaccuracies and reserves the right to modify and
revise this manual without notice.
FCC Notice
This equipment generates and uses radio frequency energy. If not installed in accordance with the manufacturer's
instructions, it may cause interference to radio and television reception. It has been type tested and found to
comply with the specifications in Subpart J of Part 15 of FCC rules for Class B Computing Devices. If this equipment
causes interference to radio or television reception – which can be determined by turning the equipment on and
off – the user is encouraged to correct the interference by one or more of the following measures: 1) Reorient the
antenna on the radio/television, 2) Connect the AC transformer to a different outlet so the programmer and radio/
television are on different branch circuits, 3) Relocate the programmer with respect to the radio/television.
If necessary, the user should consult an experienced radio/television technician for additional suggestions, or
send for the "Interference Handbook" prepared by the Federal Communications Commission. This booklet is
available from the U.S. Government Printing Office, Washington D.C. 20402, stock no. 004-000-00450-7.
The Radionics D5200 Programmer is registered with the Federal Communications Commission under part 68, for
connection to the public telephone network. FCC Registration Number: AJ9USA-65062-AL-E
Table of Contents
Chapter Page
1. Introduction ...................................................................................................................... 3
2. Overview of Operation ..................................................................................................... 7
3. Disk Operations.............................................................................................................. 10
4. Product Handlers Menu ................................................................................................. 12
5. Programming Records ................................................................................................... 14
6. Sending (Loading) Records ........................................................................................... 27
7. Receiving (Copying) Records ........................................................................................ 29
8. Passwords...................................................................................................................... 30
9. Lockcodes ...................................................................................................................... 32
10. Updating Handlers ....................................................................................................... 33
11. Deleting Handlers......................................................................................................... 41
12. Programmer Time Out ................................................................................................. 42
13. Help Screens................................................................................................................ 43
14. Inside the Programmer................................................................................................. 44
15. Troubleshooting Guide ................................................................................................. 46
D5200 Security Utility Passwords and Lockcodes Record Sheet ................................ 48
D5200 Programmer Memory Worksheet ..................................................................... 49
010