User Manual

Trouble shooting en
25
3Trouble shooting
Trouble shooting :Warning – Risk of injury!
Incorrect repairs may cause serious hazards. Repairs to
the appliance must only be carried out by a qualified
engineer. If repairs are required, contact the after-sales
service.
Fault table
Error messages
If an error message with “ appears, press the 0
button. The message disappears. A time function that
has been set is cleared. If the error message does not
disappear, please contact the after-sales service.
You can take remedial action yourself if the following
error message is displayed.
:Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out by one of our trained after-sales engineers.
Fault Possible cause Remedy/information
The appliance is not working. The circuit breaker is faulty Look in the fuse box and check that the circuit
breaker is in working order.
Power failure Check whether the kitchen light works.
Zeros are flashing on the display. Power failure Reset the clock.
The oven light has stopped working. The oven light bulb is faulty Replace the oven light bulb. (see section entitled
"Replacing the oven light bulb")
The gas burner will not ignite. Power failure or damp ignition plugs Light the gas burner with a gas lighter or a match.
The burner cap is not positioned correctly Check whether the burner cap is positioned cor-
rectly.
The oven is not heating. The fuse is faulty Check and, if necessary, replace the fuse.
The function selector has not been set Set the function selector.
All food that is cooked in the oven burns
within an extremely short period of time.
Faulty thermostat Call the after-sales service.
The door panel steams up when the oven is
hot.
Normal occurrence; caused by the difference in
temperature
Not possible; this has no effect on oven perfor-
mance.
The oven door will not open when the clean-
ing cycle is complete.
The door lock is active Turn the function selector to the "Off" position and
wait until the appliance has cooled down.
The door lock is faulty Call our after-sales service if the oven door still can-
not be opened after an extended period.
The oven will not heat or stops heating unex-
pectedly. The s symbol flashes every
0.5 seconds.
Faulty thermostat Call the after-sales service.
The oven stops heating unexpectedly. The
s symbol flashes every 2 seconds.
The appliance is too hot. Switch off the appliance and allow it to cool down. If
the fault occurs again when you next switch the
appliance on, call our after-sales service.
The cleaning function will not start. The
s symbol flashes every 4 seconds.
The oven door was opened when the door lock
was active.
Switch the appliance off and then on again.Wait a
couple of minutes before starting a new cleaning
cycle.
The fan is not turning. The fan stops when you open the oven door. This
way, less hot air escapes.
Close the oven door.
Error message Possible cause Remedy/information
“‹‚‚ A button was
depressed for too
long or is cov-
ered up.
Press all buttons individually.
Check whether any buttons
are jammed, covered up or
soiled.