Specifications

AdjustaNe Eegs
Flush
Figure 6
Figure 7
INSTALL ANTIoTIP BRACKET:
i. Adjust height of range and level by rotating the adjustable
leg supports, (see Figure 6) using i-i/4" wrench.
2. Measure to locate bracket position as shown in Figure 7.
3. Secure bracket with 2 screws.
Figure 8
Screw
\
FINAL INSTALL:
i. Move range close enough to the opening to plug into the
receptacle.
2. Slide range into position insuring that the left back leg slides
under the anti-tip bracket. Range will sit 3/4" away from back
wall when properly installed.
3. Carefully tip range forward to insure thatthe anti-tip bracket
engages the range back brace and prevents tip-over.
4. Turn on electrical power. Check range for proper operation as
described in Use and Care Manual.
Figure 9
Screw
/
Note: if LCD screen flashes and beeps, the wiring is incorrectly
installed. Immediately disconnect power at breaker and return to
step 3: CONNECT RANGECORD.
ALL RANGES CAN TIP,
_ INJURY TO PERSONS COULD
RESULT
INSTALL ANTI-TIP DEVICE
PACKAGED WITH RANGE.
SEE INSTALLATION INSTRUCTIONS
_UT£ON
DO NOT USE HAND TRUCK
OR APPLIANCE DOLLY ON
THE BACK OR FRONT OF
THIS UNIT, HANDLE FROM
SIDE ONLY!
_IL WARNING
ELECTRICAL SHOCK
HAZARD - DISCONNECT
POWER BEFORE
SERVICING,
FAILURE TO DO SO CAN
RESULT IN DEATH OR
ELECTRICAL SHOCK,
Page 6