Pmeaseread all instructions before using this applianeo Table of Contents Safety Instructions and Applicable Codes ........................................................................... Ventilation and Cabinet Preparation ....................................................................................... Range Cord Connection .................................................................................................... Anti=Tip Bracket Installation ..........................................
A n WARNING RANGE TIPPING HAZARD - TO REDUCE THE RISK OF TOP GREASE FIRF: a) Neverleave surface units unattended at high settings, Boilovers cause smoking and greasy spillovers that may ignite, Heat oils slowly on low or medium settings, ® All ranges can tip and injury coutd result. To prevent acddentai tipping of the range, attach it to the wail, floor or cabinet by installing the Anti-Tip Device supplied.
INSTALL VENTILATION It is strongly recom mended to install a hood above this range. For most kitchens with a wall mounted hood, a certified hood rating of not less than 350 CFH is recommended. Bosch hoods rated at 350 CFP1 or more when operated on High meet the above requirement and are recommended for this purpose. The range hood must be installed according to instructions furnished with the hood.
MODEL HES23 CONNECT RANGE CORD Ranges are dual rated for use on either !20/240 VAC or !20/208 VAC. See table for power ratings and circuit breaker sizes based upon the supply voltage for each mode (See chart at left:), This appliance may be connected to the power supply by installing flexible conduit or a power cord set. The electrical rating of the power cord set (not supplied) must be !20/240 volt, 50 amperes minimum for models HES.
Power Three Wire Supply Connections Connection The Four Wire Connection is preferred, but where local codes and ordinances permit grounding through neutral and/or conversion to four wire is impractical, unit may be connected to the power supply via a three wire connection. !. 2. Disconnect electrical power at breaker box. Remove the terminal block cover to expose the junction box (See Figure A). 3. Remove top nut, star washer, and round washer from each post.
Flush AdjustaNe Eegs Figure 6 Figure 7 INSTALL i. 2. 3. ANTIoTIP Screw BRACKET: \ Adjust height of range and level by rotating the adjustable leg supports, (see Figure 6) using i-i/4" wrench. Measure to locate bracket position as shown in Figure 7. Secure bracket with 2 screws. Figure 8 FINAL INSTALL: Screw i. 2. 3. 4. Move range close enough to the opening to plug into the receptacle. Slide range into position insuring that the left back leg slides under the anti-tip bracket.
BSHreserves the right responsiMe for products or BSH For deaUer, the most Home up to to change which AppUiances, date specifications are transported criticaU Corporation, installation 5060003398 or design from the 5551 dimensions without United notice, States Some modeUs are certified for use in Canada, McFadden Avenue, by fax, use your Huntington fax handset Check Beach, and CA with for use in Canada, your UocaU Canadian BSH is not distributor 92649, call 702/
