Installation Guide

19
5. Insert the flat washer.
6. Attach the red wire to the left junction block terminal
using one of the hexagonal nuts.
7. Attach the white wire to the center junction block
terminal using one of the hexagonal nuts.
8. Attach the black wire to the right junction block
terminal using one of the hexagonal nuts.
9. Properly secure strain relief.
9 WARNING
WARNING
The strain relief provided with your range cord
must be installed correctly.
10. Tighten all connections securely and replace terminal
block cover.
Note: Do not plug in the range at this time.
Connecting the three-wire flexible conduit
The four-wire connection is preferred, but where local
codes and ordinances permit grounding through neutral
and/or conversion to four-wire is impractical, the unit can
be connected to the power supply via a three-wire
connection.
1. Disconnect the electrical power at the breaker box.
Remove the terminal block cover to expose the
terminal block.
2. Insert the power supply cable into the terminal block
through the bottom hole.
3. Insert the flat washer.
4. Attach the red wire to the left junction block terminal
using one of the hexagonal nuts.
5. Attach the white wire to the center junction block
terminal using one of the hexagonal nuts.
6. Attach the black wire to the right junction block
terminal using one of the hexagonal nuts.
7. Properly secure strain relief.
9 WARNING
WARNING
The strain relief provided with your range cord
must be installed correctly.
8. Tighten all connections securely and replace terminal
block cover.
Note: Do not plug in the range at this time.