Specifications

Accessories: To purchase Bosch accessories, cleaners & parts please visit www.bosch-home.com/us/store or call 1-800-944-2904 (Mon to Fri 5 am to 6 pm PST, Sat 6 am to 3 pm PST).
Notes: All height, width and depth dimensions are shown in inches. BSH reserves the absolute and unrestricted right to change product materials and specifications, at any time, without
notice. Consult the product’s installation instructions for final dimensional data and other details prior to making cutout.
Warranties: Please see Use & Care manual or Bosch website for statement of limited warranty.
For more information on our entire line of products, go to www.bosch-home.com/us or call 1-800-944-2904
© BSH Home Appliances Corporation. All rights reserved. Bosch is a registered trademark of Robert Bosch GmbH. 09/19
30" Downdraft
800 Series Downdraft – HDD80051UC
Accessories – Transitions
6" Round transition enable ducting to be at
sides, rear or below downdraft for flexible
configurations to maximize your kitchen design
Flexible transition design allows for left,
right, rear or downward venting
Front rough-in plate may be used with a
6" round duct or elbow
Ability to use with DHG6015NUC inline or
DHG6023RUC remote blowers
Some blower positions may need deeper
cabinets. See installation guide
NOTE: HDDSTRAN6 or HDDSTRAN8 side/rear/downward transition required
for side, rear or downward exhaust applications with inline and remote
blowers.
8" Round transition enable ducting to be at
sides, rear or below downdraft for flexible
configurations to maximize your kitchen design
Flexible transition design allows for left,
right, rear or downward venting
For DHG602DUC flexible downdraft blower
used as inline installation
Some blower positions may need deeper
cabinets. See installation guide
HDDSTRAN6
6" Side/Rear/
Downward Transition
for Downdraft
HDDSTRAN8
8" Side/Rear/
Downward Transition
for Downdraft
6" Front rough-in plate enable ducting to be
at front of downdraft, for use with inline and
remote blower applications
Front rough-in plate design allows for front
venting
Front rough-in plate may be used with a 6"
round duct or elbow
Ability to use with DHG6015NUC inline or
DHG6023RUC remote blowers
8" Front rough-in plate enable ducting to be
at front of downdraft, for use with inline and
remote blower applications
Front rough-in plate design allows for front
venting
Front rough-in plate may be used with a 8"
round duct or elbow
For DHG602DUC flexible downdraft blower
used as inline installation
HDDFTRAN6
6" Round Front Plate
for Downdraft
HDDFTRAN8
8" Round Front Plate
for Downdraft
NOTE: HDDFTRAN6 or HDDFTRAN8 front plate required for front exhaust
applications with inline and remote blowers.
SIDE/REAR TRANSITIONS FOR DOWNDRAFT ROUND FRONT PLATES FOR DOWNDRAFT