Installation Guide

FPP-RNAC-8A-4C | Operation and Installation Guide | 2.0 Installing the FPP-RNAC-8A-4C
6 Bosch Security Systems, Inc. | 8/09 | F01U025431-02
2.1 FPP-RNAC-8A-4C Board
Installation
The FPP-RNAC-8A-4C board is static-
sensitive. Touch ground before handling
the board. Doing so discharges any
static electricity in your body.
1. Connect the ground wire.
2. Insert the two support posts into the control
retainer holes as shown in
Figure 2 on page 7.
3. Slide the top of the board into the retainer tabs
(the slots under the top of the frame). When it is
in the retainner tabs, the board rests on the two
support posts.
4. To secure the bottom of the board, screw the two
bottom corners through the support posts and
through to the enclosure.
2.2 Enclosure Installation
1. Use the enclosure as a template and mark the
top mounting holes on the mounting surface.
Ensure that enough clearance exists to open the
door for maintenance.
2. Pre-start the mounting screws for the two holes.
Slide the enclosure onto the mounting screws so
that the screws move up into the thinner section
of the holes. Tighten the screws.
3. Screw the remaining two screws into the bottom
mounting holes.
4. Knock out the desired wire entrances on the
enclosure.
Refer to
Figure 2 on page 7 for details.