FMR-DACT-KEYPAD Operation Instructions EN DACT Keypad Programmer
FMR-DACT-KEYPAD | Operation Instructions | 1.0 Description Notices Follow these instructions to avoid personal injury and damage to the equipment. Install, test, and maintain the FMR-DACT-KEYPAD according to these instructions, NFPA 72, local codes, and the Authority Having Jurisdiction (AHJ). Bosch is not responsible for improperly installed, tested, or maintained devices. 1.
FMR-DACT-KEYPAD | Operation Instructions | 2.0 Wiring . 2.0 Wiring Ensure all wiring is de-energized before routing. 1. 2. 3. 4. Route the wiring from the DACT to the FMR-DACT-KEYPAD. Pull the base wiring through the wire entrance in the FMR-DACT-KEYPAD base. Connect the wiring to the FMR-DACT-KEYPAD terminal strip as shown in Figure 2. Place the FMR-DACT-KEYPAD on its base. 5. While feeding the excess wiring out of the back of the base, press straight down on the cover until it latches on.
FMR-DACT-KEYPAD | Operation Instructions | 3.0 Power Up 3.0 Power Up 5.0 Setting the Address The power supplied to the FMR-DACT-KEYPAD from the DACT is 12 VDC with a maximum draw of 100 mA. The FMR-DACT-KEYPAD must have an address set within its address pins. 4.0 Installing the Instruction Label and Slide 1. 2. Place the instruction label (Item 2 in Figure 3) on the pullout slide (Item 3 in Figure 3), positioning it as close to the pull tab as possible.
FMR-DACT-KEYPAD | Operation Instructions | 6.0 Operating the Keypad . and debugging only while it is connected to the DACT. This keypad has a two-line, 16-character display showing information on various DACT programming functions. In most cases, the first line contains general system status information; the second line describes the specific programming menus and prompts. 6.0 Operating the Keypad While installing the FMR-DACT-KEYPAD, the system does not monitor the input points. 6.
FMR-DACT-KEYPAD | Operation Instructions | 7.
FMR-DACT-KEYPAD | Operation Instructions | 9.0 Specifications . 9.0 Specifications Table 2: Specifications Nominal Supply Voltage Standby Current Alarm Current Operating Temperature Relative Humidity Dimensions (H x W x D) Listings and Approvals Environmental 12 VDC 100 mA; 75 mA for battery calculation 100 mA; 75 mA for battery calculation +32°F to +120°F (0°C to +49°C) 5% to 85%, non-condensing (+86°F, +30°C) 5 in. x 6 in x 1 in.
Bosch Security Systems, Inc. 130 Perinton Parkway Fairport, NY 14450-9199 Customer Service: (800) 289-0096 Technical Support: (888) 886-6189 © 2006 Bosch Security Systems, Inc.
