Data Sheet

Fire Alarm Systems | FMM‑325A Analog Manual Stations
FMM‑325A Analog Manual Stations
www.boschsecurity.com
u Digital data communications and power provided
over two-wire circuit
u EEPROM addressing in module unit
u Rugged die‑cast housing and corrosion resistant
construction
u Single‑gang mounting
u Latching alarm lever
These manual stations are used in the polling circuit of
the Bosch Security Systems, Inc.'s FPA‑1000 Analog
Addressable Fire Panels, and the D9024, D8024, and
D10024A Fire Alarm Control Panels (FACP). They
communicate with the control panel (both power and
data) over a two‑wire polling circuit.
The manual station's address on the polling circuit is
set by programming an EEPROM microchip. The
D5070 Analog Device Programmer is required to set
the address.
All commercial buildings use manual stations. These
manual stations allow people evacuating a building to
initiate an alarm. The FACP identifies the alarm point
on the polling circuit and the alarm lever latches in the
pulled position.
Certifications and approvals
ADA Complies with Americans with
Disabilities Act ADA 4.28.3
NFPA Complies with National Fire Protection
Association NFPA 72
Region Certification
USA UL UNIU: Boxes, Non-Coded (UL38)
CSFM see our website
Installation/configuration notes
Compatibility Information
The following table lists products compatible with
these manual stations:
Active products:
FPA-1000 Analog Addressable Control Panel
D5070 Programmer
Legacy products:
FPA-1000-UL Compact Fire Panel
D10024A, D9024, and D8024 Fire Alarm Control Panels
Mounting Considerations
These manual stations are for indoor use only. They
have die-cast housings that flush mount on a single-
gang back box. For surface mounting, use an
FMM‑100BB‑R Surface‑mount Back Box.