GAS FREE-STANDING Installation CONVECTION RANGE Manual '_'(;ut< L FE, (}[JR NSPIR/_;I'K}N.
Important Safety Instructions 1! I Table of Contents Important Safety Instructions ........................................................................................ Preparation .................................................................................................................. Installation ................................................................................................................... 1 3 4 Final Steps ............................................................
Important Safety Instructions WARNING Before installing, turn power OFF at the service panel. Lock service panel to prevent power from being turned ON accidentally. CAUTION Unit is heaw and requires at least two persons or proper equipment to move. WARNING Stepping, leaning or sitting on the doors or drawers of this range can result in serious injuries and also cause damage to the range. Do not allow children to climb or play around the range.
Steps 1. Install 1 through 4: Preparation Ventilation m Bosch strongly recommends the installation of a ventilation hood above this range. For most kitchens a certified hood rating of not less than 300 CFM is recommended. The range hood must be installed according to instructions furnished with the hood. m m @ 2. Prepare Cabinets 30" Minimum Centered This unit is designed for installation near adjacent walls and projecting surfaces constructed of combustible materials, ] 30' Min.
Step 5: Installation The gas connection is located below the back panel of the range (See Figure 4, Page 3), It is accessible through the warming drawer access panel or from the back of the range, To reach access panel, remove warming drawer, Shut off main gas supply valve before disconnecting the old range and leave it off until the new hook-up has been completed, Don't forget to relight the pilot on other gas appliances when you turn the gas back on, The range can be installed using rigid pipe or a CSA I
Step 6: Final Steps = Test Burner Function 1. Turn on Power at Breaker Flame Characteristics If LCD screen flashes and beeps continuously, the wiring is incorrectly installed. Verify that wiring in house is correctly installed. If so, call Bosch Service. Yellow Flames: Further adjustment is required. 2. Test Rangetop Yellow Tips on Outer Cones: Normal for LP Gas. Burners Test Burner Ignition, Select a rangetop burner knob. Push down and turn to the flame symbol.
Step 6" Final Steps = Adjust the Flame (if necessary) _kWARNING: Allow Burner(s) to cool before attempting to remove them! Adjust Broil Burner Air Shutter Adjust Bake Burner Air Shutter (if necessary) (if necessary) Shutter More Open: *Less Yellow Screw Flame Shutter More Open: *Less Yellow Flame More Closed: *Less Blue Flame *More Carryover *Less lifting or blowing Figure 8 The air shutter is located on the back end of the broil burner, It is attached to the top of the oven cavity with 7 screws,
BSH reserves the right to change specifications for products which are transported Appliances Corporation, or design without notice, Some models are certified for use in Canada, BSH is not responsible from the United States for use in Canada, Check with your local Canadian distributor 5551 McFadden Avenue, Huntington For the most up to date critical installation dimensions or dealer, BSH Home Beach, CA 92649, by fax, use your fax handset and call 702/833-3600, Use code #8030, BOSCH 5551 McFadden A
