Specifications

Bosch Security Systems | 2003-11
EN | 7
VSS7915/00T & VS79155T | Installation Instructions
• Identify the top of the mounting box and the top of the raised-
mounting surround (the top cable entry hole is offset to the right).
• Decide the entry point (top, bottom or rear) for the cable and
break out the corresponding tabs in the mounting box and (if
required) the raised-mounting surround.
• Break out the four screw holes in the rear of the mounting box
and use these holes to mark the position for drilling the surface.
• Fit the mounting box into the raised-mounting surround.
• Mount the grommet.
• Run the connection cable through the grommet leaving about
15cm sticking out (if you enter from the top leave 20cm) and
tighten the grommet.
•Use the four 3.5 x 25mm screws (with plugs if necessary) to attach
these two units to the surface.
• Crimp the supplied connector onto the cable (see section System
Cable).
Attaching the intercom unit
The intercom unit is now ready to be fitted to the mounting box.
• Connect the cable to the unit.
• Clip the top of the unit into the top recesses of the mounting box.
• Use a finger to fold the cable back along the side of its connector
to the center of the printed circuit board. (If the cable enters from
the top make sure that it is first firmly secured in the cable guide
of the mounting box.)
• Lower the unit into place and secure underneath with the
3 x 10mm tamper-resistant screw.
• If necessary (and without touching the lens), adjust the camera
position (check the picture on the screen).
• The protective dome cannot be removed afterwards, so ensure
that you are completely satisfied with the camera position before
you click the dome into place.
• Fill-in the name card and click into place with its transparent
cover.
EazeoVideoIntercom.book Page 7 Thursday, December 18, 2003 5:57 PM