Specifications

Bosch Security Systems | 2003-11
EN | 6
VSS7915/00T & VS79155T | Installation Instructions
• Identify the top of the mounting box (the tamper-resistant screw
thread is at the bottom).
• Decide which rear entry hole (big or small) you will use for the
cable and break out the corresponding tab in the mounting box.
• Mount the metal grommet supplied (if you have chosen the
smaller rear entry point use the rubber grommet supplied).
• Run the connection cable through the grommet leaving about
15cm sticking out and tighten the metal grommet.
• Using the four short screws attach the mounting box to the frame
plate.
• Crimp the supplied connector onto the cable (see section System
Cable).
Raised mount
Raised-mounting
surround
Four 3.5 x 25mm
screws with plugs
Top recess
EazeoVideoIntercom.book Page 6 Thursday, December 18, 2003 5:57 PM