Installation manual

Bosch Security Systems | 2003-11
Eazeo DVR | Installation Manual | Chapter 2 EN | 8
2.3 Rear panel
When connecting to an Eazeo Observation System only
the connectors described below are used. The other
connectors are present to facilitate the use of the unit in
different application areas.
2.3.1 Power
Connect the power suppy cable to the power socket at
the rear of the unit. Use the power switch to switch the
unit ON or OFF.
2.3.2 Eazeo Observation Unit
The supplied cable connects the audio and video signals
from the Eazeo Observation System to the Eazeo DVR.
Note
Please note that in the following procedure the cable
connectors marked OUT are connected to the IN
sockets.
• Connect the cable connector marked VIDEO IN to
the BNC socket marked Monitor Out on the rear of
the unit.
• Connect the cable connector marked VIDEO OUT
to the BNC socket marked Video In on the rear of
the unit.
• Connect the cable connector marked AUDIO IN to
the socket marked Audio Out 1 on the rear of the
unit.
• Connect the cable connector marked AUDIO OUT
to the socket marked Audio In 1 on the rear of the
unit.
• To synchronise switching (with a multiplexer)
connect the single wire of the cable to the VEXT
connection on the rear of the unit.
2.3.3 RS232 serial connector
Connect D-Sub 9-pin connector to the RS232 port if
you want to control the unit remotely.
2.3.4 IR remote control eye connector
If the remote control IR receiver window at the front is
hidden from view (if the unit is mounted in a cupboard),
connect the optionally available extension IR cable to
the remote control connector. Position the receiver eye
so that it is in line-of-sight of the remote control unit.
2.3.5 LAN connector
To connect the unit to a network use the RJ-45 LAN
connector at the rear of the unit.
Off
Power
AC 100-240
In1 In2
Out1 Out2 Monitor Out Out Out 1 Out 2
Looping out
RS 232 Remote Control
GND ALM-NC ALM-NO ALM-CO VEXT DISKFULL NC3 NC4 GND
In
In
Video
S-VideoMonitor In
Audio Mux main
LAN
GND ALM-IN ALM-RST REC NC1 NC2 GND
100-240 Vac
VIDEO
IN
VEXT
VIDEO
OUT
AUDIO
IN
AUDIO
OUT
Power switch
RS-232
connector
IR remote
control eye
connector
Network connector
To Eazeo Observation System
VIDEO OUT
VIDEO IN
AUDIO OUT
AUDIO IN
EazeoRecorderInstal.book Page 8 Wednesday, March 3, 2004 12:23 PM