Specifications

Bosch Security Systems
DVR4C Remote Viewer | Operation Manual | Configuration Tool EN | 12
5.2.1 Information tab
The Information tab shows basic information about the
DVR.
5.2.2 Camera
Use this tab to set the video gain, brightness, and
contrast for the cameras connected to the DVR.
5.2.3 Recording
Use this tab to set the Normal Recording and Event
Recording parameters.
5.2.4 Event setup
Set the configuration of alarm inputs and the motion
detection in this tab.
5.2.5 Profiles
Use this tab to set the applicable periods for Weekday /
Weekend and day / night. Up to 30 exception days can
be configured.
5.2.6 System Settings
Use this tab to configure the various system settings.
5.2.7 Connectivity
Use this tab to set the DVR's network information;
Ethernet IP address, xDSL, PSTN and port settings.
> For more information, refer to the Network settings menu
of the DVR4C manual.
5.2.8 Disk manager
Disk setup
• When the Recording mode is set to Continuous
(default), the DVR overwrites older images when the
hard disk is full. When set to Linear, the DVR stops
recording when the hard disk is full and the
administrator has to delete video manually.
• Set a disk full warning percentage from 1 to 100%
(default 95%). A warning message is generated when
the used disk space exceeds the percentage set.
Block playback
• To block the playback of video that is older than a
certain time, select a period from the drop-down list.
This function is disabled by default.
5.2.9 Security tab
Use this tab to control access to the DVR. If you select
IP filtering, you can set up to ten IP address ranges that
are allowed or denied access to the DVR. The values
you set will normally depend on your network setup.
The IP address can be within a range from
000.000.000.000 to 255.255.255.255.
DVR4x4RemoteViewer.book Page 12 Tuesday, February 15, 2005 9:19 AM