Installation manual

Bosch Security Systems | 2004-6
DVR1C1161 | Installation Manual | Chapter 2 EN | 11
2.4.3 Single camera
The drawing below shows how to connect a single to
the DVR.
• Connect the monitor to the BNC socket marked
Video Out on the rear of the DVR.
• Connect the video output of the camera to the BNC
socket marked Video In on the rear of the DVR.
• Connect the audio output of the camera to the socket
marked Audio In on the rear of the DVR.
• Connect the socket marked Audio Out on the rear of
the DVR to an audio amplifier.
• In the system menu set the multiplexer item to Off.
Off
Power
AC 100-240
In1 In2
Out1 Out2 Monitor Out Out Out 1 Out 2
Looping out
RS 232 Remote Control
GND ALM-NC ALM-NO ALM-CO VEXT DISKFULL NC3 NC4 GND
In
In
Video
S-VideoMonitor In
Audio Mux main
LAN
GND ALM-IN ALM-RST REC NC1 NC2 GND
100-240 Vac
VEXTGND
Power switch
RS-232
connector
IR remote
control eye
connector
Network connector
Camera
Video Out
Monitor
Video In
Audio Out
Audio In
EazeoRecorderInstalC.book Page 11 Friday, August 20, 2004 2:02 PM