Installation manual

Bosch Security Systems | 2004-6
DVR1C1161 | Installation Manual | Chapter 2 EN | 10
2.4.2 Quads
The drawing below shows how to connect a quad
without a VCR output to the DVR.
• Connect the monitor to the BNC socket marked
Monitor Out on the rear of the DVR.
• Connect the video output of the multiplexer to the
BNC socket marked Video In on the rear of the
DVR.
• In the system menu set the multiplexer item to Off.
To connect a quad with a VCR output, refer to the
multiplexer connections.
Off
Power
AC 100-240
In1 In2
Out1 Out2 Monitor Out Out Out 1 Out 2
Looping out
RS 232 Remote Control
GND ALM-NC ALM-NO ALM-CO VEXT DISKFULL NC3 NC4 GND
In
In
Video
S-VideoMonitor In
Audio Mux main
LAN
GND ALM-IN ALM-RST REC NC1 NC2 GND
100-240 Vac
Video OUT
12 34
VEXTGND
Power switch
RS-232
connector
IR remote
control eye
connector
Network connector
Quad
Monitor Out
Monitor
Video
EazeoRecorderInstalC.book Page 10 Friday, August 20, 2004 2:02 PM