Installation Manual

42 en | Maintenance DSA E-Series (E2800 12-bay)
2018.02 | V1 | DOC Installaton manual Bosch Sicherheitssysteme GmbH
Lock-down code Description
L1 Missing interconnect canister.
L2 A persistent memory error has occurred.
L3 A persistent hardware error has occurred.
L4 A persistent data protection error has
occurred.
L5 An auto-code synchronization (ACS) failure
has been detected.
L6 An unsupported HIC has been detected.
L7 A sub-model identifier either has not been set
or has been mismatched.
L8 A memory configuration error has occurred.
L9 A link speed mismatch condition has been
detected in either the I/O module (IOM) or
the power supply.
Lb A HIC configuration error has been detected.
LC A persistent cache backup configuration error
has been detected.
Ld A mixed cache memory DIMMs condition has
been detected.
LE Uncertified cache memory DIMM sizes have
been detected.
LF The controller has locked down in a
suspended state with limited SYMbol
support.
LH A controller firmware mismatch has been
detected.
LJ The controller does not have enough memory
to support the configuration.
LL The controller cannot access either midplane
SBB EEPROM.
Ln A module is not valid for a controller.
LP Drive port mapping tables are not detected.
Lr A component that is not a field replaceable
unit (FRU) has been replaced.
Lt A configuration data base corruption has
been detected.
LU The SOD reboot limit has been exceeded.
In some cases, controllers detect errors during the startup process.