Installation Manual
Table Of Contents
- Table of contents
- 1 Safety
- 2 Before you begin
- 3 System overview
- 4 Installation
- 5 Connection
- 6 Turning on/off AC power
- 7 Configuring the storage system
- 8 Maintenance
- Blank Page
- Blank Page
- Blank Page
34 en | Maintenance DSA E-Series (E2800 12-bay)
2018.02 | V1 | DOC Installaton manual Bosch Sicherheitssysteme GmbH
6.0TB
6.0TB
6.0TB
3. Open the cam handle, and slide out the drive slightly.
4. Wait 30seconds.
5. Using both hands, remove the drive from the unit.
6. Place the drive on an antistatic, cushioned surface away from magnetic fields.
7. Wait 30seconds for the software to recognize that the drive has been removed.
Notice!
If you accidentally remove an active drive, wait at least 30seconds, and then reinstall it. For
the recovery procedure, refer to the storage management software.
8.1.3 Installing a drive
Install the replacement drive as soon as possible after removing the failed drive. Otherwise,
there is a risk that the equipment might overheat.
To install a drive:
1. Open the cam handle.
2. Using two hands, insert the replacement drive into the open bay, firmly pushing until the
drive stops.
3. Slowly close the cam handle until the drive is fully seated in the midplane and the handle
clicks into place.
Note: Depending on your configuration, the controller might automatically reconstruct
data to the new drive. If the unit uses hot spare drives, the controller might need to
perform a complete reconstruction on the hot spare before it can copy the data to the
replaced drive. This reconstruction process increases the time that is required to
complete this procedure.
8.1.4 After replacing a drive
After replacing a drive, you must confirm that the new drive is working correctly.
To confirm that the drive is working correctly:
1. Check the Power LED and the Attention LED on the drive you replaced.
LED status Description
The Power LED is on or blinking, and the
Attention LED is off.
The new drive is working correctly
The Power LED is off. The drive might not be installed correctly.
Remove the drive, wait 30seconds, and then
reinstall it.
The Attention LED is on. The new drive might be defective. Replace it
with another new drive.
Note: When you first insert a drive, its
Attention LED might be on. However, the LED
should go off within a minute.