User guide

DS7446KP | User Guide | 11.0 Optional Commands
30 Bosch Security Systems | 12/04 | 4998149924B
4. Press [#][Command] after you select a Chime tone. The selected tone
sounds for all Chime zones.
5. Press [# Command][6][1] to enable Chime Mode.
- Press [1] to turn Chime Mode on
- Press [2] to turn Chime Mode off
6. Press [#][Command] after you enable Chime Mode.
11.2 Change Skeds
[# Command][5][2]
A sked is a scheduling command that allows a selected event to occur at a
specific time. For example, if you need your system to turn All On at a
certain time on certain days, your alarm company can set up a sked to
meet this need. A sked can also turn an output on or off, such as lighting
or a pool pump, when needed.
Follow these steps to change a sked:
1. Press [# Command][5][2], and then select a sked type to change.
Refer to Table 15.
Table 15: Change Sked Options
Key Option
[1] Change All On Skeds
[2] Change Perimeter On Skeds
[3] Change Partial On Skeds
[4] Change Off Skeds
[5] Change Output On Skeds
[6] Change Output Off Skeds
2. Enter the time to turn the sked on or off in HH:MM format.
The valid range is 00:00 to 23:59. To disable a sked, enter 00:00 for
the time.
3. Identify which days the sked operates.
To add or remove a day, press the corresponding numeric key. Refer
to Table 16.