User guide

DS7446KP | User Guide | 8.0 Test Commands
20 Bosch Security Systems | 12/04 | 4998149924B
8.0 Test Commands
8.1 System Test
[# Command][4][1]
Use this command to determine if certain system components operate as
expected.
Your alarm company determines which components can be tested using
this command.
Table 9: Available System Tests
I Can Test This
Component
System Test
Component
Test Description
System Bell The bell output sounds for approximately
3 sec. Listen for bell activation.
System
Strobe
The strobe activates for approximately
20 sec. Check for strobe activation.
Battery The battery is tested for approximately
4 min. If this test fails, follow the instructions
on the keypad’s display.
Telephone
Line
The telephone line is tested for
approximately 10 min. If this test fails, follow
the instructions on the keypad’s display.
Press [*] to stop the test currently in progress, and skip to the next test.
Press [# Command] to stop all system tests, and exit this command.
8.2 Walk Test
[# Command][4][4]
Use this command to walk-test detection devices as determined by your
alarm company.
Perform this test at least once a week.
Test fire detection devices such as smoke detectors and heat detectors as
instructed by your alarm company.