User guide

DS7446KP | User Guide | 3.0 Keypad Overview
12 Bosch Security Systems | 12/04 | 4998149924B
3.3 System Status Messages
Refer to Table 5 for descriptions of the system messages that can appear
on the keypad’s display.
Table 5: System Status Messages
Keypad Display Description
System OK.
There are no system troubles.
System Trouble!
Press 4 to view.
A system trouble exists. Refer to Section 9.3 View
System Troubles on page 22 for more information.
Zones faulted.
Press 0 to view.
One or more zones are faulted. Refer to Section 9.1
View Faulted Zones on page 21 for more information.
Logged Out!
This message appears when you press [# Command]
twice to log out of the system. The system remembers
PIN entries for approximately 10 sec. after you stop
pressing keys.
OK for All On
All zones are normal and the system is ready to turn on.
OK for Perimeter
You cannot turn your system All On, but you can turn it
on Perimeter Only or Partial On. You must fix the faulted
zone before you can turn your system All On.
Not Ready
You cannot turn your system on. You must fix the faulted
zone before you can turn your system on. Refer to
Section 9.1 View Faulted Zones on page 21, and
Section 9.2 View Zone Troubles on page 21, for more
information.
Tamper!
Unable to Arm
A tamper condition exists. You cannot turn your system
on until you fix the tamper condition.
Trouble!
Unable to Arm
A major trouble condition exists. You cannot turn your
system on until you fix the trouble condition.
Trouble!
Force Arm Required
If this message appears when you try to turn the system
on, you must force arm the system. This message
appears if a data bus trouble occurs or AC power fails
when you try to turn the system on.