Bosch ventilation installation manual DPH36652UC - DPH30652UC
APPROVED FOR RESIDENTIAL APPLIANCES FOR RESIDENTIAL USE ONLY READ AND SAVE THESE INSTRUCTIONS PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. INSTALLATION MUST COMPLY WITH ALL LOCAL CODES. IMPORTANT: Save these Instructions for the Local Electrical Inspector’s use. INSTALLER: Please leave these Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. Safety Warning: Turn off power circuit at service panel and lock out panel, before wiring this appliance.
IMPORTANT SAFETY INSTRUCTIONS Read All Instructions Before Using the Appliance. READ AND SAVE THESE INSTRUCTIONS WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. B. Before servicing or cleaning the unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally.
IMPORTANT SAFETY INSTRUCTIONS Read All Instructions Before Using the Appliance. READ AND SAVE THESE INSTRUCTIONS Electrical requirements IMPORTANT IMPORTANT Save Installation Instructions for electrical inspector’s use. Observe all governing codes and ordinances. The range hood must be connected with copper wire only. It is the customer’s responsibility: To contact a qualified electrical installer.
Parts Included with your Hood • • • • Parts Not Included with your Hood Hood Canopy Assembly with blower, grease filters and lamps already installed Care & Use /Installation Instructions Transition Fittings bag with: 4 Washers 6 Drywall anchors 2 Hooks with regulating screws 6 Screws 5X35 4 screws for transition • • • • • • Duct Tape 1/2" Conduit Wire Nuts Round or Rectangular Duct.
• Typical installation The height from the countertop to the bottom of the hood is 24" to 30”.These hoods are not recommended to be used over indoor grills. 1. Choose vent options The hood is designed ready to be used for vertical discharge as shown below. Note: see also Fig. 1-3-5 for Cabinet preparation. If desired, the hood can be converted for horizontal discharge as shown below. Note: see also Fig. 2-3-5 for Cabinet and rear wall preparation.
TOTAL (of both columns)= 7
TABLE 2. DUCTWORK INSTALLATION GUIDELINES For safety reasons, ducting should vent directly outdoors (not into an attic, underneath the house, into the garage or into any enclosed space). Keep duct runs as short and straight as possible. Duct fittings (elbows and transitions) reduce air flow efficiency. Back to back elbows and „S“ turns give very poor delivery and are not recommended. A short straight length of duct at the inlet of the remote blower gives the best delivery.
2. Discharge Direction: The hood is shipped ready for vertical discharge. Keyhole Pin WARNING! Before installing remove the knock-out plate that close the air outlet on the top if is desired to use the range hood for vertical discharge OR the rear outlet if is desired to use the range hood for horizontal discharge. (see also Figure 5). NOTICE Once the Knock out plate has been removed, this cannot be reinstalled anymore close the air outlet (see also Figure 5).
Wall Mount Installation HOOD WIDTH DIM. "W" DIM. "K" DIM. "Z" 30" 29 - 1/8" 2 - 1/2" 7 - 1/16" 36" 35 - 1/16" 2 - 1/2" 7 - 1/16" Note: see below if cabinet installation is preferred 4. After the hood installation height has been determined draw a horizontal line at a distance above the cooktop equal to the desired hood installation height plus 7- 1/ 2”. See also Figure 6a. 5. Find the centerline of the cooktop.
Fix Duct to transition and seal with tape. For both installation method: 12.Wiring the HOOD: WARNING Electrical Shock Hazard Turn off power at the service panel before wiring this unit. 120 VAC, 15 or 20 Amp circuit required. ELECTRICAL GROUNDING INSTRUCTIONS THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE APPLIANCE.
