User Manual
Table Of Contents
- [en] Instructions for installation and use
- Table of contents
- [en] Instructions for installation and use
- ( Important safety information
- Important safety information
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- Causes of damage
- Saving energy
- Environmentally-friendly disposal
- Exhaust air mode
- Air recirculation
- Control panel
- Setting the fan
- Intensive setting
- Fan run-on time
- Lighting
- Cleaning agents
- Cleaning the metal mesh grease filters
- Removing metal grease filter
- Installing the metal mesh grease filter
- Malfunction table
- Replacing bulbs
- LED lights
- Accessories
- ( Important safety information
- Important safety information
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- : Warning
- K General information
- Exhaust air mode
- Exhaust duct
- Electrical connection
- Preparing the units
- Appliance dimensions and safety clearances
- 1. Make the cut-out for the exhaust air pipe. To do this, make an opening in the top or back panel of the fitted unit with an additional recess for the power cord.
- 2. If the cabinet base is in place, remove it. Mark the fastening points on the inside of the cabinet and use a bradawl to make indentations where the holes are to be. To help you mark the fastening points, use the fastening piece provided.
- Body wall thickness: 16 mm
- Body wall thickness: 19 mm
- Appliance dimensions and safety clearances
- Preparing the appliance
- Sliding the appliance up into place
- Sliding out the appliance
- Note:
- 1. Use a flat-blade screwdriver to push in the fastening bolt, and turn it 90° until it locks into place. ¨
- 2. Push in the fastening bolt gently with your fingers, and turn it until it comes out of the housing along with the spring.©
- 3. Carefully remove the appliance.
- 4. Screw in the filler strip fully.
- 5. Push in the fastening bolt and turn it 90°.
- Note:
- Note:
- Final fitting stage
- Connecting the pipes
- Removing the appliance
en Installation
14
Sliding out the appliance
Note: Before you remove the appliance, protect the hob
with a piece of polystyrene from the packaging.
1. Use a flat-blade screwdriver to push in the fastening
bolt, and turn it 90° until it locks into place. ¨
2. Push in the fastening bolt gently with your fingers,
and turn it until it comes out of the housing along
with the spring.©
Pull gently on the fastening bolt; before you do this,
take hold of the appliance from beneath with the
other hand. ª
3. Carefully remove the appliance.
4. Screw in the filler strip fully.
5. Push in the fastening bolt and turn it 90°.
Note: The fastening pieces on the left and right of
the appliance must be able to move.
Final fitting stage
1. Slide the appliance up into place. ¨
2. Lock the fastening bolts on the left and right. ©
3. Fit the protective caps on the left and right. ª
4. Establish the electrical connection.
Note: The extractor hood's housing can be concealed
within the upper cabinet. In doing so, you must observe
the following:
■ The intermediate floor must not be placed on the
extractor hood's housing.
■ The front panel must not be secured to the housing.
■ Access must be available in order to change the
filter and for the after-sales service.
$ %
&
[
%
$
&