Technical data

• DOK-DIAX02-DDC01******-PRJ1-EN-E1,44 • 01.97

4. Mounting the DDC 1.2

4.3. Power Connections

The protection category of the power terminal connectors (X7) of the DDC, the

motor power terminal (X5), and the NC control unit interface (X8) is IP 65.

The motor feedback cable and the connections for the optional plug-in cards

are inserted in the DDC. These connections run through the cable leadthrough

along the underside of the DDC. These must be carefully installed to maintain

the IP 65 protection category.

1. release screw 1

2. open shroud 2

3. release knurled screw 3

4. remove cover 4

5. remove gasket 5

6. place cable in gasket 6

7. reverse mounting order for closing up

8. tighten screw 1

Installation guidelines

for cable leadthrough

EXDDC

DDC

Fig. 4.3: Installing the cable leadthrough