Technical data

10
• DOK-DIAX02-DDC01******-PRJ1-EN-E1,44 • 01.97
1. Introducing the System
1.6 Configuration Rating Plate
The configuration rating plate contains the type codes for:
• the configured servo drive
• the basic unit
• the software module in slot U5
• the plug-in cards in slots U1 through U4
These type codes can be used to determine which components must be
located in which slots.
In the event of malfunctions, the information on the configuration rating plate
can be used to obtain a corresponding unit or to configure a basic unit. A
replacement unit results when a basic unit is configured with the cards
identified on the configuration rating plate.
The configuration rating plate indicates which cards are installed on
the servo drive. Before commisioning the servo drive, check to be
certain that the actual configuration matches that on the configuration
rating plate.
Fig. 1.3: An example of a configuration rating plate
TSDDC
SYSTEMCONFIGURATION
DDC 1.2-N100A-DL01-01-FW
DDC 1.2-N100A
FWC-DSM 2.1-C11-02V02-MS
DLC 1.1
DEA 4.1
COVER
COVER
U
1
U
2
U
3
U
4
U
5
TYS-DDC 1.2-N050C-DL01-00
slot designation
type of configured
drive controller
basic unit type
type of plug-in
module
type of software
module
configuration rating
plate type
COVER = there is no plug-in module in this slot