User manual

DCN Next Generation Open Interface Release 2.4 Appendix DCN Wireless
en | 277
Bosch Communications Systems | 2007 February | MMI_AQ_INF | AQ041402
1. INTRODUCTION
1.1 Purpose
The purpose of this document is to define the user interface of the Remote Interface Description.
1.2 Scope
This document describes the user interface for the Remote Interface Description. It is not a
functional specification of all aspects of the Remote Interface Description.
Only the changed or added functionality comparing with the DCN NG remote interface
description has been described. The available DCN NG remote interface descriptions can be
found in: [SRS_INF], [SRS_ SCSIINF], [SRS_ MMINF], [SRS_ CCINF], [SRS_ ININF], [SRS_
VTINF], [SRS_ LDINF], [SRS_ MDINF], [SRS_ ATINF], [SRS_ ICINF].
1.3 Definitions, Acronyms and Abbreviations
.
1.4 References
MMI_AQ_INF This document
Error! Reference
source not
found.
SRS_INF General Remote Interface Du010933.doc
SRS_SCSIINF SC & SI & DB Remote Interface Description Du010934.doc
SRS_MMINF MM Remote Interface Description Du020903.doc
SRS_CCINF CC Remote Interface Description Du020905.doc
SRS_ININF IN Remote Interface Description Du030905.doc
SRS_VTINF VT Remote Interface Description Du040905.doc
SRS_LDINF LD Remote Interface Description Du080902.doc
SRS_MDINF MD Remote Interface Description Du090902.doc
SRS_ATINF AT Remote Interface Description Du100902.doc
SRS_ICINF IC Remote Interface Description Du110902.doc
1.5 Summary
Three OI applications have been changed, System Configuration (SC), System Installation (SI)
and Microphone Management (MM).
Chapter 3 and 4 describes the SC changes, chapter 5 and 6 describes the SI changes and
chapter 7 and 8 describes the MM changes.
For each application the additional defines are added in the appendixes.