User`s guide

D621 Series | User's Guide | View Point Trouble (Cmd 48)
Bosch Security Systems | 8/04 | 41
View Point Trouble (Cmd 48)
o I can perform this command.
o I cannot perform this command.
Use this command to view which points (if any) are in trouble.
1. Make sure the system is turned off (All and Part indicators
are off).
2. Press [Cmd] [4] [8]. The keypad may prompt you to enter
a valid passcode by flashing the Cmd light.
3. Enter your passcode. The keypad displays all points that
are in trouble (if any). Refer to Table 7.
The keypad only displays Points 1 to 16.
Table 7: Trouble Points
Point Trouble Condition
Off No Point Trouble
On Wiring Fault
Flashing Slow RF Sensor Low Battery
Flashing Fast RF Sensor Missing
4. Press [Cmd] twice to exit the View point trouble
command.