User`s guide

D621 Series | User's Guide | View Alarm Memory (Cmd 40)
Bosch Security Systems | 8/04 | 38
3. Press [Cmd] to exit this command.
The trouble tone for Power Failure events sounds
at all keypads in all areas. However, the trouble
tone must be silenced in each area (silencing it in
one area does not silence it in the other areas).
View Alarm Memory (Cmd 40)
o I can perform this command.
o I cannot perform this command.
After an alarm has been silenced and cleared from the display,
you may still review the points that were in alarm.
1. Make sure the system is turned off (All and Part indicators
are off).
2. Press [Cmd] [4] [0]. Enter passcode if prompted. The
keypad displays all points that are in alarm memory.
3. To clear the alarm memory, turn the system on and then
off.
• If the point indicator is flashing fast, the point is
currently in alarm.
• If the point indicator is flashing slow, the alarm
was aborted. No reports for the alarm event were
sent to the security company.