Specifications

ISW-D8125CW-V2 | Installation and Operation Guide | Operation
.
Bosch Security Systems, Inc. | 8/11 | F01U161691-05 9
3.0 Operation
3.1 Commercial Wireless Interface
Module Quick Startup
Recommendations
The following information details the recommended
programming steps that should be taken when
installing a commercial wireless interface module in a
new installation.
1. Press the [2] key and change the Installer Passcode,
if necessary.
Refer to Section 3.9.6 Changing the Installer Passcode
on page 13.
If you lose or forget the Installer
Passcode, you must send the commercial
wireless interface module in for repair to
reset the Installer Passcode. The default
passcode is 123456.
2. Press the [1] key to add RF Transmitters to the
system.
Refer to Section 3.9.1 Add or Edit an RF Transmitter
on page 11).
3. Press the [DIAG] key to test the system during and
after installation.
3.2 Labeling the Bosch Transmitters
Prior to programming the Bosch transmitters or
commercial wireless interface module, it is
recommended that you take the time now to apply the
point number labels from the Point Label Sheet to the
individual transmitters.
3.3 Keypad Overview
To access the keypad on the commercial wireless
interface module, open the door by gently pulling on
the tab on the bottom center of the keypad (Figure 8).
Figure 8: Front View
TX1
RX1
TX2
RX2
1
2
3
4
5
1 - TX1 LED (Transmit LED for Receiver 1)
2 RX1 LED (Receive LED for Receiver 1)
3 TX2 LED (Transmit LED for Receiver 2)
4 RX2 LED (Receive LED for Receiver 2)
5 Tab to open front door
Refer to Figure 9 for an overview of the built-in keypad.
Figure 9: ISW-D8125CW-V2 Keypad
1
PREV
DIAG
NEXT
ENTESC
2
3
4
5
6
7
8
9
0
2
1
1 - LCD display
2 Keys (refer to Table 2 on page 10)