Specifications

ISW-D8125CW-V2 | Installation and Operation Guide | Installation

6 Bosch Security Systems, Inc. | 8/11 | F01U161691-05

4. Connect the wiring (refer to Figure 6 on page 7, or

Figure 7 on page 8) to the commercial wireless

interface module and mount the cover unit to the

base.

Figure 5: ISW-D8125CW-V2 Mounting Options

1 - Four-screw mounting holes

(for mounting on an electrical box)

2 Two-screw mounting holes

(for mounting on an electrical box or in control

panel enclosure)

3 Wire routing openings

2.3 Wiring the Commercial Wireless

Interface Module to the Control

Panel and EN4200 Serial Receiver

Disconnect all power to the control panel

and to the commercial wireless interface

module before starting any work with the

internal components.

For UL Listed installations, install the

commercial wireless interface module

within 20 ft (6 m) of, and within the same

room as, the EN4200 Serial Receiver.

The maximum distance from the control

panel to the commercial wireless interface

module cannot exceed 5 ft

(1.5 m).

For best transmitter reception results, place the

EN4200 Serial Receiver in a central location among

the transmitters. If transmitters are too far away for the

receiver to pick up the transmission, install an

ISW-EN5040-T Commercial Wireless RF Repeater.

Certain installation configurations may require a

second EN4200 Receiver.

Refer to Figure 6 on page 7, and Figure 7 on page 8, for

proper wiring connections.