Specifications

ISW-D8125CW-V2 | Installation and Operation Guide | Installation
.
Bosch Security Systems, Inc. | 8/11 | F01U161691-05 5
2.0 Installation
The commercial wireless interface module
is packaged with a Point Label Sheet.
Save these, as you will use them when
identifying the point numbers on the
Bosch transmitters.
2.1 Configuring the Commercial Wireless
Interface Module
2.1.1 Register (REG) Pins
By default, the commercial wireless interface module is
configured to register RF transmitters with a single
press of the transmitter’s reset button.
You can also configure the commercial wireless
interface module to require two presses of the RF
transmitter’s reset button to register the RF transmitter.
Refer to Figure 2 to set the REG pins.
Figure 2: Register (REG) Pins Settings
REG RCV
11
22
P1P2
1
REG RCV
11
22
P1P2
2
1 - Single-press setting (default configuration)
2 Double-press setting
2.1.2 Receiver (RCV) Pins
If you set the RCV jumper on the
commercial wireless interface module to
1 or remove the jumper plug from the
RCV pins, you can use only one receiver
and it must be connected to the Receiver
1 terminals on the commercial wireless
interface module. Refer to Figure 1 on
page 4 for the location of the RCV
jumper.
The commercial wireless interface module supports up
to two ISW-EN4200 Receivers.
By default, the commercial wireless interface module
supports one receiver. Refer to Figure 3 to set the RCV
pins.
Figure 3: Receiver (RCV) Pins Settings
REG RCV
11
22
P1P2
1
REG RCV
11
22
P1P2
2
1 - Setting for one receiver (default configuration)
2 Setting for two receivers
2.2 Mounting the Commercial Wireless
Interface Module
1. Select the knockout from the control panel
enclosure that will be used to route the wiring.
Figure 4: Enclosure Knockout Options
Wire
Knockouts
D8103 Enclosure shown.
2. Select the location from which the commercial
wireless interface module’s wiring will be routed.
3. Remove the base of the commercial wireless
interface module.