Specifications

ISW-D8125CW-V2 | Installation and Operation Guide | Operation
.
Bosch Security Systems, Inc. | 8/11 | F01U161691-05 13
3.9.4 Adding an Existing RF Transmitter
It may be necessary to add an already installed
transmitter again to the commercial wireless interface
module, especially if the transmitter was deleted using
the RF Transmitter menu option (refer to Section 3.9.1
Add or Edit an RF Transmitter on page 11). In this case,
the RF transmitters can be re-added to the commercial
wireless interface module.
If you need to change the point type of an
existing RF transmitter, program the
transmitter is if it were a new transmitter.
Refer to Section 3.9.3 Adding a New RF
Transmitter on page 12.
Refer to Section 5.0 Program Record
Sheet on page 17 for point types when
replacing an RF transmitter or the
commercial wireless interface module.
To add an existing RF transmitter:
1. Follow the steps in Section 3.9.1 Add or Edit an RF
Transmitter on page 11 to reach the RF Transmitter
status display (Figure 17 on page 11).
2. After you select a point number, the keypad cycles
through the following displays. Refer to Figure 18
on page 12.
3. Press [3] to continue adding the RF transmitter.
4. The keypad presents two options:
- Push 1 for new xmtr. (transmitter)
- Push 2 for existing xmtr.
5. Press [2] for an existing RF transmitter.
6. The keypad shows Ptxxx added.
xxx = the RF transmitter’s point number.
The point number of the RF transmitter is
automatically incremented.
7. Record the point information in Section 5.0 Program
Record Sheet on page 17 and on the RF transmitter’s
point label.
8. Repeat this procedure to re-add other RF
transmitters.
3.9.5 Deleting an RF Transmitter
To delete an RF transmitter:
1. Follow the steps in Section 3.9.1 Add or Edit an RF
Transmitter on page 11 to reach the RF Transmitter
status display (Figure 17 on page 11).
2. After you select a point number, the keypad cycles
through the following displays. Refer to Figure 18
on page 12.
3. Press [2] to delete the RF transmitter.
4. The keypad beeps twice and shows Ptxxx deleted
to indicate that the RF transmitter was deleted.
xxx = the RF transmitter’s point number.
The point number of the RF transmitter is
automatically incremented.
5. In Section 4.0 Troubleshooting on page 17, indicate
which RF transmitter was deleted.
6. Repeat this procedure to delete other RF
transmitters.
3.9.6 Changing the Installer Passcode
If you lose or forget the Installer
Passcode, you must send the commercial
wireless interface module in for repair to
reset the Installer Passcode.
By default, the Installer Passcode is 123456. To change
the Installer Passcode:
1. From the main menu (Figure 15 on page 11),
press [2].
The keypad shows Enter existing
passcode:******.
2. Enter the current passcode.
If you incorrectly enter the passcode, a three-beep
error tone sounds, and the keypad shows Invalid
code... The keypad then returns to the main menu.
3. After entering a valid passcode, the keypad shows
Enter new passcode:******.
Enter a new six-digit passcode.
4. The keypad prompts you to re-enter the new
passcode. Enter it again.
5. If both entries match, the keypad shows Passcode
changed.
If you incorrectly enter the passcode, a three-beep
error tone sounds, and the keypad shows Invalid
code... The keypad then returns to the main menu.
6. To exit the Installer Passcode menu, press [ESC].