Specifications

ISW-D8125CW-V2 | Installation and Operation Guide | Operation
10 Bosch Security Systems, Inc. | 8/11 | F01U161691-05
Table 2: Key Descriptions
Key Description
ESC
Escape: Backs out of a programming option
or menu level.
ENT
Enter: Accepts a program entry.
PREV Manually scrolls to a previous menu or point
selection. This key also stops the auto-
scrolling of the menus.
NEXT Manually scrolls to the next menu or point
selection. This key also stops the auto-
scrolling of the menus.
DIAG
Shortcut to RF Diagnostics menu (see Section
3.9.9 RF on page 14).
A single beep indicates entry is
acknowledged. Two beeps indicate valid
entry. Three beep tones indicate an input
error was made.
3.4 Initial Power-up
When the commercial wireless interface module is
powered, it displays the idle text (Figure 10, Figure 11 or
Figure 12).
• Figure 10 appears if no transmitters are
programmed into the commercial wireless
interface module.
• Figure 11 appears if one or more transmitters are
already programmed in the commercial wireless
interface module and are not missing.
• Figure 12 appears if the commercial wireless
interface module has a system fault.
Figure 10: System Defaulted Display
3.5 RF System OK
If the system is OK, the keypad shows Figure 11.
Figure 11: RF System Normal
3.6 Call for Service
The keypad shows Figure 12 if one of the following
conditions occurs:
• EEPROM Failed
• Receiver Missing
• Programmed RF Points Missing
• Tamper Trouble
Figure 12: Call for Service
3.7 Factory Default Passcode
The commercial wireless interface module contains a
single passcode. To access the functions in the
commercial wireless interface module, this passcode
must be entered first. The default passcode loaded at
the factory is 123456 + [ENT]. This passcode can be
changed at any time from within programming mode.
To enter the default passcode, press 123456 + [ENT].
Figure 13: Invalid Code Display
3.8 Entering Invalid Passcodes
If you enter an invalid passcode, the keypad displays
Figure 13. If an invalid passcode is entered four
consecutive times, the keypad displays Figure 14.
The commercial wireless interface module disallows
any further entries for 5 minutes, unless power is
cycled to the unit.
Figure 14: Invalid Code/Keypad Locked Display