Specifications

24 | Installation instructions
C 1210 ES/ESC6 720 644 887 (2014/11)
If wall is sheathed with plaster or drywall, it is recommended that two
support boards, either 1"x 4" or 1/2" (minimum) plywood first be
attached across a pair of studs, see fig. 26, page 24.
▶ Secure the wall mounting bracket provided with the heater to a wall
surface. The heater must be kept level on the wall surface, see fig.
27, page 24.
▶ Hang the appliance on the bracket, see fig. 28, page 25.
Fig. 26 Distance between support boards
[1] Studs 16" (406mm) on center
Fig. 27 Leveling wall mounting bracket
Fig. 28 Mounting the heater
Front cover should be removed (see instructions on page
8) in order to inspect components visually.
WARNING:
▶ Do not install this appliance on a carpeted wall. The
heater must be mounted on a wall using appropriate
anchoring materials.
WARNING:
▶ In areas where outside temperature is routinely
below 32°F and the heater is to be installed on the
inside of an exterior wall, a minimum 2" air gap or
rigid insulation between the heater back and the wall
is recommended.
WARNING:
▶ Appliance must be installed vertically.
6720608158-64.1AL
6720608158-05.1AL6720608158-05.1AL