Instruction manual

en Trouble shooting
14
The vacuum in the plastic bag
is not retained.
The bag is defective. Sharp parts of the food (such as bones)
may poke holes in the bag.
Check the bag for damage. Use a differ-
ent bag if it is damaged. If the damage is
caused by sharp-edged parts of the food,
as far as possible, position these in the
bag in such a way that they cannot dam-
age the wall of the bag.
The heat-sealed seam is
defective.
The heat-sealing time you have selected
is unsuitable for the plastic from which
the bag is made.
Select a different heat-sealing time.
There is liquid, grease or crumbs along
the heat-sealed seam. The bag has
creases along the heat-sealed seam.
Make sure that the bag is dry, that it has
no creases, and that it is positioned fully
on the heat-sealing bar.
Use a different bag. Fold over the edge
of the bag by 3 cm before you fill it.
The lid cannot be opened. A slight vacuum has formed and it is
holding the lid closed.
Do not use force or tools to open it. Initi-
ate vacuum-sealing again and then can-
cel it immediately.
Disconnect the appliance from the
mains power supply. Wait 30 seconds
and then start up the appliance again.
Touch the on/off symbol for more than 5
seconds. The system is reset.
Fault Error Causes Possible remedy