Owner's Guide

en-us
8
Electrical connection
WARNING
Risk of electric shock and fire if electrical
connection is not installed properly!
Plug into a fixed, grounded 3-prong outlet only. The
outlet must be installed and grounded according to
code by a qualified electrician. If necessary, have
the installation inspected by a qualified technician
to ensure it is properly grounded.
Do not use an extension cord or power strip.
Never connect the appliance to an electronic
energy saver plug (such as Ecoboy, Sava Plug,
etc.) or to power inverters which convert direct
current (DC) to alternating current (AC) (such as for
solar equipment, power supplies on ships, etc.).
The outlet for the appliance must be located close the
appliance and must be easy to access also after
installation.
Connect the appliance to a properly installed
115 V/60 Hz AC outlet. The fuse for the outlet must be
rated either 15 A or 20 A.
If the appliance is to be used in a country other than
the U.S., check the rating plate to determine if the
specified voltage and current type correspond to the
ratings of your power supply. If the voltage and current
type do not match, the appliance must not be
operated. The power cord may only be replaced by a
qualified electrician.
Aligning the appliance
NOTICE
To ensure that the appliance operates correctly, use
a level to align the appliance.
If the appliance is not level, water may flow out of the
ice maker, ice cubes may be irregular, or the doors
may not close properly.
1. Place the appliance in the designated location.
2. Remove the three screws from the base panel.
3. Remove the base panel.
4. Use a 36 mm open end wrench to loosen the two
front feet until they are firmly planted on the floor
and then align the front of the appliance.