Technical data

PTZ SETUP
HOME SETTING
SCHEDULE
MISC FUNCTION
RESTORE DEFAULTS
EXIT
Autopan
Autopan means the motion of scanning an area horizontally so that the camera can catch the
horizontal view. The parameters are as follows.
AUTOPAN
Autopan 01
Start Point PT Move
End Point PT Move
Direction Right
Speed 9° sec.
Dwell Time 001
Run Autopan Enter
Exit YES
Autopan
There are four sets of Autopan Lines built into the camera. You can select a line to execute by
pressing LEFT/RIGHT direction keys. In addition, you can command the camera to do endless
panning by setting the start point the same as the end point.
Start Point
Follow the description below to set the start position of the AUTOPAN path.
1. Move the cursor to <START POINT> and press <CAMERA MENU> while the item, <PT
MOVE>, is flashing. Then the item will turn <TO SAVE> automatically.
2. Point the camera lens to a desired position and press <CAMERA MENU> to save the
position as the start point. The cursor will move to <END POINT> automatically. Be sure
to set the end point to complete Auto Pan setting.
Notice!
The tilt and zoom values of the start point will be recorded and fixed for the selected
Autopan line.
End Point
You can set the end point after the start point is defined. Pan the camera lens to another
position and press <CAMERA MENU> to save the position as the end point.
Direction
You can set the AUTOPAN direction of the camera. The camera will start to pan clockwise from
the start point to the end point if <RIGHT> is selected here, and then return to the start point.
The camera will start to pan anti-clockwise from the start point to the end point if the
selection is <LEFT>. Refer to the diagram below.
6.12.1
AUTODOME 5000 Analog PTZ Camera On-Screen Display (OSD) Menu | en 41
Bosch Security Systems, Inc. Operations Manual 2013.07 | 1.3 |