Technical data

Assembly Instructions
1. Attach the Bubble (6) to the Camera Body (5) and fasten the two M3x23L screws (7).
2. Attach the Sunshield (4) to the Camera Body (5) by fastening the three (3) M4x21L
screws.
3. Attach the Outdoor Adaptor (2) to the Camera Body (5) by turning clockwise and fasten
the M5x8L screw (1) after all cables are connected to the camera back plate.
Notice!
If the Dome Camera will be attached to a wall or pipe mount, ensure that the Outdoor
Adaptor is attached to the wall or pipe mount prior to attaching the Camera Dome Body.
Accessories
The AUTODOME 5000 Series PTZ Dome camera comes with the hardware and installation
instructions necessary to mount the camera to a ceiling.
These following mounting accessories are available (and are supplied with separate mounting
instructions):
Model Number Description Application
VEZ-A5-WL Wall Mount Indoor/outdoor vertical walls
VEZ-A5-PP Pipe Mount Indoor/outdoor high ceilings
VEZ-A5-IC In-ceiling (Recessed)
Mount
Indoor drop-ceiling
VDA-CMT-PTZDOME Corner mount adapter Indoor/outdoor corner (used
with the VEZ-A5-WL Wall
Mount)
VDA-POMT-PTZDOME Pole mount adapter Indoor/outdoor mast (used
with the VEZ-A5-WL Wall
Mount)
!
Caution!
Installation
The installation should be made by qualified installation personnel and conform to the
National Electrical Code and applicable local codes.
Danger!
Servicing
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT PERFORM ANY SERVICING OTHER THAN
THAT CONTAINED IN THE OPERATING INSTRUCTIONS, UNLESS YOU ARE QUALIFIED TO DO
SO.
In USA and Canada, use Class 2 power supply unit (PSU) only.
5.11
22 en | Connection AUTODOME 5000 Analog PTZ Camera
2013.07 | 1.3 | Operations Manual Bosch Security Systems, Inc.