Technical data

Connection

Switches/Connectors

Configuring the camera’s ID and communication protocol is required before connecting the

camera to other devices. The switches used for configuring these settings are located on the

camera’s back plate.

Refer to the diagram and table below for positions and definition of the switches / connectors.

Letter Description

A Alarm I/O

B Camera ID setup dip switch

C BNC video output

D Communication switch

E Camera control protocol switcher

F RS-485 connector

G Power connector

5.1

AUTODOME 5000 Analog PTZ Camera Connection | en 15

Bosch Security Systems, Inc. Operations Manual 2013.07 | 1.3 |