Data Sheet

2 | ASWP Series Weatherproof Horn Strobes
Modules SM‑12/24‑R Synchronization module (red)
DSM‑12/24‑R Dual synchronization module (red)
1
For synchronization, use the SM or DSM modules with
these control panels. The synchronization module must be
set for 24 V operation. When used, the D7022 must be set
for 24 VDC operation.
2
When used with a D7039 Multiplex Expansion Module, the
D7024 becomes an addressable fire alarm control panel
(FACP).
Mounting Considerations
Outdoor or Severe Environment Applications
For an outdoor application or a severe environment
(NEMA 3R) application, mount the horn strobe and a
WPBB‑R Weatherproof Back Box on a flat wall or ceiling so
the entire rear surface of the back box is covered. The drain
holes in the back box must point toward the ground. The
knockouts on the rear surface of the back box must remain
intact.
The knockout hole on top of the back box is sized for a
half‑inch conduit and matching connector. A proper
watertight conduit fitting must be used.
Mount these horn strobes on the indicated back box for the
indicated applications:
Conduit
Applications
Surface
Mounted
Flush
Mounted
WPBB‑R • •
All models have an attractive cover plate for a clean,
finished appearance.
Wiring
Note Do not use these units in coded or pulsed
signaling circuits.
The input terminals accept wires with diameters between
18 AWG (1.2 mm) and 12 AWG (2.3 mm).
Parts Included
Quant. Component
1 Horn strobe
1 Cover plate
1 Hardware pack
1 Literature pack
Technical Specifications
Environmental Considerations
Relative humidity: Up to 95%, non‑condensing
Temperature (operating): -31°F to +150°F (-35°C to +66°C)
Mechanical Properties
Dimensions
(H x W x D):
4-13/16 in. x 4-13/16 in. x 2-1/2 in.
(12.2 cm x 12.2 cm x 6.4 cm)
Material: Molded plastic enclosure incorporating a Xenon flash-
tube and Lexan lens.
Candela Ratings
(on axis):
75 cd at -31°F (-35°C)
180 cd at +77°F (+25°C)
Power Requirements
Current (maximum RMS)
High dBA 168 mA VDC; 235 mA FWR
Medium dBA 155 mA VDC; 225 mA FWR
Low dBA 150 mA VDC; 220 mA FWR
Voltage Ranges
24 V nominal: 16.0 to 33.0 VDC or FWR
Sound Output Ratings (reverberant dBA at 10 ft [3 m]) at 24 VDC
Continuous Horn
High Volume Setting: 91 dBA
Medium Volume Setting: 88 dBA
Low Volume Setting: 83 dBA
Temporal (Code 3) Horn
High Volume Setting: 87 dBA
Medium Volume Setting: 84 dBA
Low Volume Setting: 79 dBA
Trademarks
Trademark names are used throughout this document. In
most cases, these designations are claimed as trademarks
or registered trademarks in one or more countries by their
respective owners. Rather than placing a trademark symbol
in every occurrence of a trademark name, Bosch Security
Systems, Inc. uses the names only in an editorial fashion
and to the benefit of the trademark owner with no intention
of infringing the trademark.
Lexan is a registered trademark of General Electric Corporation, USA, in the
United States and other countries.