Installation Manual
Table Of Contents
- 1 Important Information
- 2 Safety Instructions
- 3 Introduction
- 4 Technical Data
- 5 Installing
- 5.1 Mounting
- 5.2 Unmounting
- 5.3 Opening the Case
- 5.4 Closing the Case
- 5.5 Cabling
- 5.6 Grounding and Shielding
- 5.7 Connecting Power Supply
- 5.8 Ethernet Interface
- 5.9 RS-485 Host Interface
- 5.10 RS-232 Host Interface
- 5.11 DIL switch selector
- 5.12 RS-485 for extension modules
- 5.13 Wiegand Interface for Card Readers
- 5.14 Connecting Relay Outputs
- 5.15 Connecting Analog Input Devices
- 5.16 Tamper Protection
- 6 Operating
- 7 Appendix
64 en | Index AMC2 4W
V 7.6 | 2008.12 Installation manual Bosch Sicherheitssysteme GmbH
Index
C
cabling 27
characteristics
17
contact 6
D
description 12
DIL 14, 17, 39
display 54
E
equipment 14
Ethenet host interface 15
Ethernet host interface
17
Ethernet interface 32
extension interface 20, 30
extension interfade
41
G
grounding 28
H
host interfaces 14, 17, 20, 29, 33
I
I/O board 41
inputs 15, 17, 20, 51
interfaces
Ethernet
56
extension 20, 30
host
14, 17, 20, 29, 32, 33, 38
reader 15, 17, 20, 43
interfades
extension
41
L
LCD 54
M
mounting 23
O
offline capability 12
opening 25
outputs 15, 17, 20, 48
overview
18
P
power supply 27, 31
R
reader interfaces 15, 17, 20, 43
Wiegand
43
resetting 57
resistor 51
RS-232 host interface
14, 17, 38
RS-485 host interface 14, 17, 33
four wire 37
two wire
36
S
Safety notes 9
shielding
28
system overview 18
T
tamper 53
transfer rates 17, 20
U
unmounting 24