Installation Manual
Table Of Contents
- 1 Important Information
- 2 Safety Instructions
- 3 Introduction
- 4 Technical Data
- 5 Installing
- 5.1 Mounting
- 5.2 Unmounting
- 5.3 Opening the Case
- 5.4 Closing the Case
- 5.5 Cabling
- 5.6 Grounding and Shielding
- 5.7 Connecting Power Supply
- 5.8 Ethernet Interface
- 5.9 RS-485 Host Interface
- 5.10 RS-232 Host Interface
- 5.11 DIL switch selector
- 5.12 RS-485 for extension modules
- 5.13 Wiegand Interface for Card Readers
- 5.14 Connecting Relay Outputs
- 5.15 Connecting Analog Input Devices
- 5.16 Tamper Protection
- 6 Operating
- 7 Appendix
62 en | Appendix AMC2 4W
| V 7.6 | 2008.12 Installation manual Bosch Sicherheitssysteme GmbH
Table 7.3 Power supply
Table 7.4 Wiegand interface
Table 7.5 Analog input
Table 7.6 Relay output
1 Power supply, DC positive (10V - 30V)
2Shield
3Power supply (0V)
4 UPS (power good signal) - AC
5 UPS (power good signal) - Battery
6 UPS (power good signal) - DC
7 UPS (power good signal) - Common
1 Reader Supply - 12V+
2 Reader Supply - 0V
3 Data 0
4 Data 1
5Shield
6 green LED
7red LED
8Beeper
9Hold
10 Card Present
1Analog Input, in
2Analog Input, out
1 Relay Output, normally open
2 Relay Output, common
3 Relay Output, normally closed