Installation Manual
Table Of Contents
- 1 Important Information
- 2 Safety Instructions
- 3 Introduction
- 4 Technical Data
- 5 Installing
- 5.1 Mounting
- 5.2 Unmounting
- 5.3 Opening the Case
- 5.4 Closing the Case
- 5.5 Cabling
- 5.6 Grounding and Shielding
- 5.7 Connecting Power Supply
- 5.8 Ethernet Interface
- 5.9 RS-485 Host Interface
- 5.10 RS-232 Host Interface
- 5.11 DIL switch selector
- 5.12 RS-485 for extension modules
- 5.13 Wiegand Interface for Card Readers
- 5.14 Connecting Relay Outputs
- 5.15 Connecting Analog Input Devices
- 5.16 Tamper Protection
- 6 Operating
- 7 Appendix
56 en | Operating AMC2 4W
| V 7.6 | 2008.12 Installation manual Bosch Sicherheitssysteme GmbH
6.2 Configuring the Ethernet Interface
To configure the AMC2 in a TCP/IP network environment, use
the AmcIpConfig tool provided in the following directory on the
standalone or the remote server of the Building Integration
System:
\\Runtime-drive:\MgtS\AccessEngine\AC\bin
The access control system Access Personal Edition has an
entry of this tool in its program folder:
Start > Programs > Access Personal Edition > AmcIpConfig
This tool can be copied and used on every computer on the
network.
!
CAUTION!
Use only alphanumeric characters plus the seperator "-" (minus/
dash).
The network name has to start with a letter. Do not use
special characters or spaces.
The names are not case sensitive.
i
NOTICE!
Please consult the AmcIpConfig tool’s own online help for
details on configuring the AMC2.