Installation Manual
Table Of Contents
- 1 Important Information
- 2 Safety Instructions
- 3 Introduction
- 4 Technical Data
- 5 Installing
- 5.1 Mounting
- 5.2 Unmounting
- 5.3 Opening the Case
- 5.4 Closing the Case
- 5.5 Cabling
- 5.6 Grounding and Shielding
- 5.7 Connecting Power Supply
- 5.8 Ethernet Interface
- 5.9 RS-485 Host Interface
- 5.10 RS-232 Host Interface
- 5.11 DIL switch selector
- 5.12 RS-485 for extension modules
- 5.13 Wiegand Interface for Card Readers
- 5.14 Connecting Relay Outputs
- 5.15 Connecting Analog Input Devices
- 5.16 Tamper Protection
- 6 Operating
- 7 Appendix
AMC2 4W Operating | en 55
Bosch Sicherheitssysteme GmbH Installation manual | V 7.6 | 2008.12
3 Dig. IO: :::::::::::::::: Display of the digital contacts:
the input signals set will be
shown with an extension above
- output signals with an
extension below.
3a Dig. I1: :::::::::::::::: If there are I/O-Boards
connected the signals will be
shown on separate pages.
3b Dig. I2: ::::::::::::::::
3c Dig. I3: ::::::::::::::::
4 MAC 0010174C8A0C Network device address (MAC)
5 N AMC-1234-5678 Network name of the AMC2
6 I 192.168.10.18 IP-address of the AMC2
7 G 192.168.10.255 IP-address of the gateway
(Version V 00.44 or higher)
8 M 255.255.255.0 Subnetmask
(Version V 00.44 or higher)
9 H 192.168.10.10 IP-address of the host
computer
10 DHCP 1 DHCP-status:
1 = on
0 = off
11 D 192.168.10.1 IP-address of the DNS server
12 Host: + "C" Host activity:
+ = online
- = offline
"C" = Counter of the received
data packages from the host
interface.
Push Display (Example) Description