Installation Manual
Table Of Contents
- 1 Important Information
- 2 Safety Instructions
- 3 Introduction
- 4 Technical Data
- 5 Installing
- 5.1 Mounting
- 5.2 Unmounting
- 5.3 Opening the Case
- 5.4 Closing the Case
- 5.5 Cabling
- 5.6 Grounding and Shielding
- 5.7 Connecting Power Supply
- 5.8 Ethernet Interface
- 5.9 RS-485 Host Interface
- 5.10 RS-232 Host Interface
- 5.11 DIL switch selector
- 5.12 RS-485 for extension modules
- 5.13 Wiegand Interface for Card Readers
- 5.14 Connecting Relay Outputs
- 5.15 Connecting Analog Input Devices
- 5.16 Tamper Protection
- 6 Operating
- 7 Appendix
AMC2 4W Installing | en 47
Bosch Sicherheitssysteme GmbH Installation manual | V 7.6 | 2008.12
Wiegand reader type W 4
The reader has an additional DIL switch to choose the following
parameter settings.
1 green LED
2red LED
3 Data 0
4 Data 1
5-
6 Reader Supply - 0V
7 Reader Supply: 8 - 30VDC
8-
9-
10 -
S1 = on The beeper is controlled by input 1.
S2 = on The beeper will allways be set after
card reading.
S3 = on The LED displays will be controlled by
the reader.
S4 = off
S5 = on The beeper is controlled by input 2.
i
NOTICE!
In the default delivery status pin 2 is set to ON.