Installation Manual
Table Of Contents
- 1 Important Information
- 2 Safety Instructions
- 3 Introduction
- 4 Technical Data
- 5 Installing
- 5.1 Mounting
- 5.2 Unmounting
- 5.3 Opening the Case
- 5.4 Closing the Case
- 5.5 Cabling
- 5.6 Grounding and Shielding
- 5.7 Connecting Power Supply
- 5.8 Ethernet Interface
- 5.9 RS-485 Host Interface
- 5.10 RS-232 Host Interface
- 5.11 DIL switch selector
- 5.12 RS-485 for extension modules
- 5.13 Wiegand Interface for Card Readers
- 5.14 Connecting Relay Outputs
- 5.15 Connecting Analog Input Devices
- 5.16 Tamper Protection
- 6 Operating
- 7 Appendix
40 en | Installing AMC2 4W
| V 7.6 | 2008.12 Installation manual Bosch Sicherheitssysteme GmbH
Table 5.1 Setting the address via the DIL switch
Table 5.2 Protocol and connection settings
Address
DIL Switches
1234
none OFF OFF OFF OFF
1 ON OFF OFF OFF
2OFFON OFF OFF
3 ON ON OFF OFF
4OFFOFFON OFF
5 ON OFF ON OFF
6OFFON ON OFF
7 ON ON ON OFF
8OFFOFFOFFON
Mode
DIL Switches
56
ON SDEB RS-232
OFF BPA RS-485